Options - Low-Voltage Motors - Siemens  |   11/21/2008 10:25 PM  
Hide Images  |  Print

MICROMASTER 411 and COMBIMASTER 411 – Options

Variable-speed Drives for Decentralised Tasks

Software and Operator Control

Basic Operator Panel (BOP)

With the BOP, individual parameter settings can be made. Values and units are shown on a 5-digit display.
A BOP can be used for several inverters. It is mounted in the operator panel mounting kit, for connection to the external communication interface of the inverter.
 

Advanced Operator Panel (AOP) for MICROMASTER 411/ COMBIMASTER 411

This AOP is used specifically for the MICROMASTER 411/COMBIMASTER 411 products.
The AOP enables parameter sets to be read out of the inverter or to be written into the inverter (upload/download). Several different parameter sets can be stored in the AOP. It has a plain-text display with the possibility of switching between several languages.
It is mounted in the operator panel mounting kit, for connection to the external communication interface of the inverter.
 

Commissioning Tools

STARTER is start-up software for guided commissioning for MICROMASTER frequency inverters under Windows NT/2000. Parameter lists can be read out, altered, stored, entered and printed.
DriveMonitor is start-up software for list-oriented parameterization of frequency inverters. This program can run under Windows 95/ 98/NT/2000/XP Professional.
Both programs are part of the Docu-CD supplied with each unit.
Communication Modules

PROFIBUS Module

PROFIBUS controlled operation is possible up to 12 Mbaud/s. The PROFIBUS module can be powered from an external 24 V supply so that the bus is active when the power is removed from the inverter.
The PROFIBUS module in the form of a separate module can be screwed onto the case of the MICROMASTER 411/COMBIMASTER 411.
 

AS Interface Module

This module enables the COMBIMASTER 411/MICROMASTER 411 inverter to communicate as a slave in an AS Interface (actuator-sensor interface) communications network.
In a standard AS Interface system, up to 31 slaves can be connected, whereby each slave has up to 4 inputs and up to 4 outputs. The module uses an external housing.
 

ECOFAST PROFIBUS Module

This module enables the ECOFAST variants of the COMBIMASTER 411 and MICROMASTER 411 inverters to communicate in a PROFIBUS communications network. The transmission speed is 12 mbps.
The module also permits connection to three external inputs (2 digital and 1 analog) and one digital output via M12 connector. The ECOFAST PROFIBUS module is accommodated in an external housing.
 

ECOFAST Options (Especially for Addressing Connectors)

The ECOFAST PROFIBUS module has an addressing socket so that the PROFIBUS address can be set with the PROFIBUS addressing connector (Order No.: 6ES7194-1KB00-0XA0), which is available as an option.
For more information on ECOFAST cables, connectors and options, see Catalog LV1.
 

DeviceNet Module

This module enables the COMBIMASTER 411/MICROMASTER 411 inverters to communicate as nodes in a DeviceNet communications network.
The DeviceNet module allows transmission speeds of 125, 250 and 500 kbps. The module uses an external housing.
Brake Function Modules

EM Module (Electromechanical Brake Control Module)

This module controls an electromechanical brake mounted on the motor. The module is for mounting on the case of the MICROMASTER 411/ COMBIMASTER 411. For more information on the motor brake, see Catalog M11 "Technical Explanations", "Brakes".
 

REM Module (Rheostatic Brake and Control Module for Electromechanical Brake)

This module contains a brake chopper with brake resistor and controls an external electromechanical motor brake. The module is enclosed in an external housing with the same degree of protection as the product series.
Siemens AG 2008