|
|
 |
We protect your investment - 
Siemens Services for FactoryLink Customers
In May 2007, Siemens announced the acquisition
of UGS Corp. ., expanding the range of automation technology provided by Siemens - particularly in the area of product lifecycle management software..
|
|
|
With the release of FactoryLink Version 8 SCADA,
a decision was announced by Siemens to stop future product enhancements and place the product in maintenance mode.
This decision allowed the former FactoryLink development team to form a HMI Center of Competence (CoC)
to focus on helping to enhance the Siemens
SIMATIC WinCC products for the general market and to develop automated technology for
FactoryLink customers to migrate to SIMATIC WinCC.
Existing Customer Support & Service (CSS) contracts for versions 6.6, 7.5, and 8.0 will be honored
without restrictions until October 2012. Sustaining engineering for operating system revisions,
layered product revisions, and defect correction will be provided under the terms of a CSS contract.
|
 |
|
|
To protect your investment, FactoryLink customers are being offered cost-effective and low-risk options to switch to a powerful,
future-proof SCADA platform with all the benefits of the "Totally Integrated Automation" concept from Siemens.
A network of contacts in the HMI CoC in Richardson, Texas, USA, are ready to answer all your questions about support options and
to provide expert migration assistance.
You may contact the HMI CoC directly at
go2wincc.sea@siemens.com.
|
|
|
|
|
