Print document

Technical Forum

SIMOVERT MASTERDRIVES

cuvc card

Thread Starter: edison65   Started: 8/11/2012 5:31 PM   Replies: 3

« Previous thread Next thread »
Page 1 of 1 (4 items)
  8/11/2012, 5:31 PM
edison65
Joined 10/11/2011
Last visit: 5/11/2013
Posts: 28
Rating:
Rated: no ratings [0 out of 5 / rated 0 time(s)]. (0) 
Rated: no ratings [0 out of 5 / rated 0 time(s)]. (0) 
hi please help me i have bad problem.
i have a simovert vc , the cuvc destroyed then i install a new cuvc. how dio i install a new cuvc first?
what parameter must i set first for identification cuvc?
 i set power sction definition with supply voltage 380 v , is that ok?


thank you 
Top
  8/11/2012, 6:07 PM
MNA
Joined 6/16/2012
Last visit: 5/13/2013
Posts: 20
Rating:
Rated: Above avarage [3 out of 5 / rated 2 time(s)]. (2) 
Rated: no ratings [0 out of 5 / rated 0 time(s)]. (0) 
edison65 wrote:
hi please help me i have bad problem.
i have a simovert vc , the cuvc destroyed then i install a new cuvc. how dio i install a new cuvc first?
what parameter must i set first for identification cuvc?
 i set power sction definition with supply voltage 380 v , is that ok?


thank you 



Hi edison65,

First of all, I assume you have a backup of your CUVC program, either in the OPS1 or in your computer in Drive Monitor / Drive ES.

If you do, first P053 should be changed in order to enable parameterization either by OP1S or CBP2.


After you download all the parameters, you have to manually change the parameters related to the power section definition (P070, P071, P072, P073). See comment in the manual attached.

I hope this helps.

Regards,
MNA


Attachment: Powersectiondefinition.jpg  (25 Downloads)
Top
  8/13/2012, 8:45 PM
enku
Joined 3/25/2008
Last visit: 5/16/2013
Posts: 28
Rating:
Rated: no ratings [0 out of 5 / rated 0 time(s)]. (0) 
Rated: no ratings [0 out of 5 / rated 0 time(s)]. (0) 
Hei,
do you need configure first the Power unit,
Changing the Cu, then parameter P60 to 8 (power definition)
then, p070 (mlfb) the same for your backups, and change it.
next, P060 to 7 and weiting to finish the prcedure.

At last transfer your backup.
Only, observ yours version from Cu before you dowload it.

enku
Top
  8/13/2012, 10:21 PM
mcmyr
Joined 5/3/2011
Last visit: 4/25/2013
Posts: 9
Rating:
Rated: no ratings [0 out of 5 / rated 0 time(s)]. (0) 
Rated: no ratings [0 out of 5 / rated 0 time(s)]. (0) 
I made a step-by-step instructions for this configuration, but in Portuguese. I’ll translate it to English and I’ll publish here soon.
Top
Thank you for this post from:
dchartier
Page 1 of 1 (4 items)
Actions
Copy Link
To conference