S7 Distributed Safety Configuration and Programming

Course Description

• This course is aimed at everyone who wants to learn the handling, fault diagnosis, engineering and commissioning of the SIMATIC S7-300F fail safe automation system as well as the philosophy of failsafe controllers, the diagnosis and fault handling /correction
  

Course content

• Overview of the standards and guidelines.
• PLC S7-300F ( principle, system configuration and peripherals)
• Configuring Distributed Safety (system parameterization, programming, system handling, fault diagnosis, documentation, and acceptance) with Distributed Safety.
• Fail safe peripherals with Distributed Safety.
  
• Diagnosis (CPU-Diagnosis, Peripherie-Diagnosis, further diagnosis tools).
  

Target Group

• Project Design, Programming and Commissioning
  

Pre-requisite

• Pre-requisite knowledge assumes a basic knowledge of control and PLC concepts.
• An understanding and experience with Step 7 Software or
• Completion of the S7 Prog1 , introduction to Step 7
  

Learning Objectives

• Exercises in configuring peripherals, communication, troubleshooting.
• Examples of programming, (Emergency Stop, protective door, safety- oriented tripping, passivation, programming features).
  

• You will be working in a fully simulated manufacturing environment as shown below.
• Siemens Training Courses are developed and accredited for and delivered by
  Siemens only.
  
  
  
  S7 315F Training Case