Print document

Technical Forum

SINUMERIK CNC automation systems

810T No Simulation

Thread Starter: Jeff C.   Started: 7/16/2012 2:41 PM   Replies: 3

« Previous thread Next thread »
Page 1 of 1 (4 items)
  7/16/2012, 2:41 PM
Jeff C.
Joined 12/9/2008
Last visit: 9/19/2012
Posts: 8
Rating:
Rated: no ratings [0 out of 5 / rated 0 time(s)]. (0) 
Rated: no ratings [0 out of 5 / rated 0 time(s)]. (0) 
After 4 years of finally getting my machine repaired,I finally get it up and running,except there is no longer the simulation function on my 810T control.
How do I enable this function?

Also,what setting changes the control to read in inches instead of metric?
As of now the home reads 70.000 X and 170.00 Z

Thank You,
Jeff
Top
  7/17/2012, 2:16 PM
garanimanu
Joined 5/3/2012
Last visit: 2/3/2013
Posts: 31
Rating:
Rated: Excellent [5 out of 5 / rated 4 time(s)]. (4) 
Rated: no ratings [0 out of 5 / rated 0 time(s)]. (0) 
for enable simulation please check the display machine data 9600 and 9603 ,
 for changing metric to to inch system che the General machine date 10240

Regards 
Mohan Garani
Top
  7/17/2012, 4:38 PM
Pee El Sea
Joined 1/19/2008
Last visit: 5/21/2013
Posts: 373
Rating:
Rated: Excellent [4.63 out of 5 / rated 16 time(s)]. (16) 
Rated: no ratings [0 out of 5 / rated 0 time(s)]. (0) 
Hi,

WHen changing over units you have to convert all values into the new units yourself. The system will not do it for you.

Pee
Top
  7/17/2012, 6:19 PM
Jeff C.
Joined 12/9/2008
Last visit: 9/19/2012
Posts: 8
Rating:
Rated: no ratings [0 out of 5 / rated 0 time(s)]. (0) 
Rated: no ratings [0 out of 5 / rated 0 time(s)]. (0) 
I dug around the machine manual and found it.
It's under the MD 5002.
Thanks for your help!
Top
Page 1 of 1 (4 items)
Actions
Copy Link
To conference