Technical Forum

STEP 7 (TIA Portal)

How can i change the parameter values in the DB instance?

Thread Starter: RKarczewski Started: 6/14/2012 12:04 PM Replies: 1

6/14/2012, 12:04 PM

RKarczewski

Joined 7/12/2007

Last visit: 5/9/2013

Posts: 103

Rating:

Rated: Outstanding [4 out of 5 / rated 1 time(s)].

(1)

Rated: no ratings [0 out of 5 / rated 0 time(s)].

(0)

Hello!

A few questions about TiA Step7 V11:
1. How can I change the parameter values in the DB Instance? Was super "facilitate" was based on the absence of such a possibility? Now do it in the Variable Table, but at 400 DB is a little "tired" and it gets reproduce what actually is.
[schnippschnapp]
thank you

=== Edited by O_Moderator @ 6/19/2012 1:58 PM [GMT ] ===
subject edited after other questions were splitted to
Is it possible to suspect a block line, and not the whole project?
How to view a specific FB call?
How to separate the editors Step7 and WinCC?
Is there a list of keyboard shortcuts known from Step7 2010.
Why can not I have both installed WinCC TiA Adv. / Prof. with SCADA WinCC 7.0?

industrial automation specialist

Top

6/15/2012, 12:18 PM

Pegaia

Joined 7/24/2008

Last visit: 5/22/2013

Posts: 2029

Rating:

Rated: Excellent [4.31 out of 5 / rated 354 time(s)].

(354)

Users with special expertise supervising conferences

(0)

Hi,

1) you can change "variables" in the Watch Table or directly on the loggic (by monitoring, right mouse click, modify...). However, if you have mutch to setup, maybe should be to think to use a HMI with recipes features.
[schnippschnapp]

=== Edited by O_Moderator @ 6/19/2012 2:02 PM [GMT ] ===

Denilson Pegaia
Siemens Industry Sector
Industry Automation and Drive Technologies Division
- Technical Support & Hotline -
Rua Werner Siemens, 111
05069-900 São Paulo
Hotline – Atenção ao Cliente
Tel.: +55 11 3833-4040
E-Mail: atencao.cliente.ac.br@siemens.com
Homepage Brasil: www.siemens.com.br
Manuais / FAQ’s / Downloads: http://www.Siemens.com.br/Servicos&Suporte

Top

Actions

Copy Link

To conference