SIMODRIVE Converter system

Traverse blocks in Axes 2 Not Updating

Thread Starter: SteveOwen   Started: 6/5/2012 6:12 PM   Replies: 1

  6/5/2012, 6:12 PM

SteveOwen Joined 6/5/2012 Last visit: 2/8/2013 Posts: 2 Rating:  (0)

(0)  Hi, My first post so please go easy =D I have a 2 Axis 611u simodrive positioning application but i cannot transfer the traversing blocks necessary to axis 2. I used the example software in the 611 toolbox but for some reason I cannot get the traverse information into the traverse table in drive 2. The addresses are correct and control is fine, I just cannot move single parameters. When I trigger a write I have no busy signal and no done signal afterwards. To adjust traverse positions I must use SimoComU. Maybe some guidance on where I might start to fault find would be nice. Everything seems good and profibus comms to drive 2 are working. just the single traverse parameters do not transfer. Drive 1 works perfectly. Thanks. Steve

Top

  6/7/2012, 3:02 PM

SteveOwen Joined 6/5/2012 Last visit: 2/8/2013 Posts: 2 Rating:  (0)	(0)  Bump Does anyone have any guidance on this? i will post some images from the software to show exactly whats going on. If someone can help but requires more information please let me know. As far as I can see everything is configured correctly. Regards, Steve
	Top