Process Control Systems SIMATIC PCS 7

parameter assignment error preventing start up

Thread Starter: chitturi   Started: 6/2/2012 4:56 PM   Replies: 2

  6/2/2012, 4:56 PM

chitturi Joined 7/21/2008 Last visit: 5/16/2013 Posts: 10 Rating:  (0)

(0)  Dear All, Can any body let me know the solution for the below mentioned probelm. PCS7 V7.0 SP1 with hardware 417-4ht14 firmware v4.5.5 redundant system.  while configuring hardware i had used the 417-4ht14 ,v4.5 After downloading the programme,  CPU is not going to run mode. attached the diagnostic buffer. Is above hardware will support PCS7 V7.0 SP1 or any updates required. regards, chitturi Attachment: New Bitmap Image.JPG  (21 Downloads)

Top

  6/6/2012, 10:53 AM

Silent Bob Joined 2/24/2011 Last visit: 5/17/2013 Posts: 674 Rating:  (58)	(0)  Has this CPU been in the catalog of HW config dialog? kind regards Silent Bob Tips & Tricks of forum usage - which contents are allowed:
	Top

  6/7/2012, 8:12 AM

Yoga Shankar Joined 6/12/2009 Last visit: 9/14/2012 Posts: 288 Rating:  (15)

(0)  chitturi wrote: Dear All, Can any body let me know the solution for the below mentioned probelm. PCS7 V7.0 SP1 with hardware 417-4ht14 firmware v4.5.5 redundant system.  while configuring hardware i had used the 417-4ht14 ,v4.5 After downloading the programme,  CPU is not going to run mode. attached the diagnostic buffer. Is above hardware will support PCS7 V7.0 SP1 or any updates required. regards, chitturi Best try and get the latest HSP from this site for PCS7 V7.0. Then your hardware catalog will have all the latest released modules for your PCS7 version. try replacing the existing CPU's with the proper firmware version . IMPOSSIBLE SPELLS I'M POSSIBLE

Top