DC converters SIMOREG

PZD4 satus word

Thread Starter: ZUMA   Started: 7/16/2012 10:30 AM   Replies: 4

  7/16/2012, 10:30 AM

ZUMA Joined 6/22/2009 Last visit: 2/23/2013 Posts: 33 Rating:  (0)	(0)  Helo Sir I have a problem determining the parameter used in SIMOREG DC MASTER (6RA7085 6DV62 -0 -Z) connected through profibus using PPO4 0 PKW/ 6 PZD on PLC CPU 314 C 2 DP. How can I know what parameter is used in PZD4 (status word 2)since I cannot determine it in PLC. (I have already know PZD1-3). Please help me sir? === Edited by ZUMA @ 7/16/2012 10:45 AM [GMT ] ===
	Top

  7/16/2012, 11:09 AM

KSN Joined 8/25/2006 Last visit: 5/22/2013 Posts: 899 Rating:  (85)	(0)  Hello. By default configuration PZD4 from drive to PLC is status word 2. Look in the manual, function diagram Z110, G183. You may check what was configured in your drive as PZD4 in parameter U734.04.
	Top

  7/17/2012, 4:40 AM

ZUMA Joined 6/22/2009 Last visit: 2/23/2013 Posts: 33 Rating:  (0)	(0)  Does U734.04 shows the actual value sir or  parameter used (like torque, current etch). I have read in the manual that PZD4 can link to other parameter instead of status word 2.
	Top

  7/17/2012, 5:26 AM

KSN Joined 8/25/2006 Last visit: 5/22/2013 Posts: 899 Rating:  (85)	(0)  Hello. U734.04 shows the connector number which is sended as PZD4 via 1st communication board of the drive. Look what the value has U734.04 in your drive, then refer to the manual, chapter 12.1 (Connector list), here you will find what is sended as PZD4.
	Top

  7/17/2012, 8:56 AM

ZUMA Joined 6/22/2009 Last visit: 2/23/2013 Posts: 33 Rating:  (0)	(0)  Thanks very much sir
	Top